OP, if you are putting the sight on the rails then you will be fine, all sights of the same type are the same height (to my knowledge) someone else might prove me wrong but i never seen a sight that was diffrent (unless it was used in the wrong way like the magpuls on the gas block.
#Magtec ar15 magtool free#
The gas block is lower than the rear sight, so they have to be higher, and the ones that goes onto the rails are shorter because the free floats are higher than the gas block. there are two types of front sights, ones that go on gas block (they sit higher) and ones that go on rails (shorter). The magpuls are designed to go onto a free float rail. The original innovators behind Mag Magnet, California’s essential AR-15 bullet button tool, also manufacture the 360 VFG adjustable fore grip, the most flexible, comfortable grip you will ever own, and the TX3 Tactical Takedown Tool. To be honest, I don't know if its gas block is lower than standard or not. I guess that your rifle is different than mine is, so they may work fine for yours.īy the way, I use a DPMS 16" heavy barrel upper. I do like both of the Magpul sights, and if there were some way to make my front gas-block higher, I'd use the front sight too. Therefore, I ended up getting a UTG front sight, which I was able to zero. I used the rear sight however, the front sight was too low for my AR. Not just looking to be the lightest on the market Mag Tactical Systems reinforced key areas of the receiver including the front pivot pin location and the trigger and hammer pin area. I have both the Magpul front and rear sights. Ultra-light proprietary magnesium alloy from Mag Tactical has their AR15 lower receiver being 35 lighter than standard lowers on the market today.
0 kommentar(er)
